 |
Pfaff Fringe Presser Foot (Cat J)
Information for Pfaff Fringe Presser Foot (Cat J)
Pfaff Fringe Presser Foot (Cat J).
Use the Fringe Presser Foot to create loop embroidery as if by magic. It‘s a whimsical effect that looks especially good on terry cloth or velvet.
1. Mark your desired pattern with a fabric marking pen.
2. Place a piece of stabilizer under the fabric.
3. Set the upper thread tension to 2 - 3 (loosen the tension until no bobbin thread comes to the surface).
4. Select a zigzag stitch. Length 0.5 to 1.0. Sew the stitches row by row. For circles, work from the outside in.
5. When using heavier threads, you should select a slightly longer stitch length. Sew a test sample first.
6. When finished, pull the work carefully from the machine by holding the last loops. If you pull too quickly, you will pull the end loops flat/tight.
7. Knot the beginning and end threads on the reverse side. Use seam sealant to prevent loops from being pulled.
TIP: This foot can be used to create tailor tacks.
Caution: Stitch width not to exceed 6 mm, but not narrower than 2.5 mm.
For Pfaff Category J Machines.
Writing guidelines
